B C R 2
3v Battery Component Replacement
We now offer the BCR 2, which is used in the PS2, three volt system. If your PS2 engine uses a battery pack with two AA batteries, in a blue plastic wrap, or 2 AAA batteries in a green plastic wrap or your engine has been upgraded to PS2, you can now replace that battery with the BCR 2. Check with your instruction to see if the PS2 engine uses a three volt or the instruction say: 2.4 volt battery.
The BCR 2 is a permanent replacement for the battery and plugs into the battery connector. Power up your engine in neutral, at ten volts or more for one minute, and the engine will be ready to run, regardless of how long the engine has been sitting.
When the BCR 2 needs to be charged, the sound volume will be lower than normal. While the BCR 2 is charging up, the sound level will return to normal, still wait one full minute, the BCR 2 will charge up and your engine will be ready to run.
In command mode, run your engine for one minute and the BCR 2 will be charged. The BCR 2 will hold a charge, after turning the power off to the engine, for over a week! If you run your engine at least once a week, you will never have to wait to charge up the BCR 2.
At anytime the sound level is lower than normal, the BCR 2 will need to be charged.
Back to J and W Electronics